top of page
Number of SSV's:
Heading 3
Number of Solutions:
Heading 3
Suspected Sources of Variations (SSV's) | Tool for pinpointing | Technical solutions |
|---|---|---|
Holding chucks not balanced | OBS | Balance chucks |
Imbalance | OBS | Dynamically balance end mills over 1.0 inch in diameter |
Imbalance in tool holder | OBS | Use balanced block or hollow-mill type of tools |
Improper broach design or sharpening | VS | Review design for specific application and check sharpening practice |
Improper chaser seating | OBS | Disassemble and clean holders and clamps |
bottom of page